ATTENTION! To avoid injury or damage to the device, be sure to read and follow the instructions in this manual before use.
1. Warnings
• Install the control unit in a room with a suitable temperature (from 0°C to +40°C). Do not use the device in excessively dusty or humid environments, as this may lead to its malfunction.
• Exercise caution when using the handpiece (hereinafter: micromotor). Never allow it to fall, as this can cause significant damage to structural elements and components of the micromotor (such as: housing, ball bearings, collet chuck, coupling, motor rotor).
• Avoid the ingress of water or any other liquids or solvents outside and especially inside the micromotor and control unit.
• After replacing the working attachment, before the next operation, make sure the collet is closed. Also, never attempt to open the collet while the micromotor is in operation.
• After completing work with the device, ensure that the collet chuck is closed, and a protective insert or attachment is installed in it. Closing the collet without a protective insert can damage the collet assembly.
• When connecting the power cable of the control unit to the electrical network, make sure that the power switch is in the "OFF" position. This device is intended for dental, jewelry, milling work, and nail care.
• This device should be used by professionals familiar with the basic principles of operation and safety techniques for devices of this type.
2. Controls and Their Functions
